Status Displays - Guntermann & Drunck DVICenter DP32 Installationsanleitung

ADVICE: You can establish a direct connection between a target and a user module of
the network fails or a port at the central module does not work properly.
Use a category 5e (or better) crossover cable to connect both modules.
USB 2.0 Devices: Connect up to 4 USB devices to these interfaces.
Connect the power cable to the power pack and a power outlet.
Power In:

Status displays

The blinking Transmission LEDs show the following connection statuses:
LED Colour Status
Left Yellow Off
On
Right Green On
Blinking
Flashing
Meaning
No connection to network.
A user module is accessing the target module.
A user module is accessing the target module.
No communication with central module.
Connection to central module established successfully.
No user module is accessing.
User modules » U2-R-CON
G&D DVICenter DP32 · 54