Installing And Connecting User Modules; Connecting Console Devices To User Modules; Connecting User Modules To The Central Module - Guntermann & Drunck DVICenter DP32 Installationsanleitung

Installing and connecting user modules

IMPORTANT: You can place user modules up to 140 metres away from the central
module.

Connecting console devices to user modules

 Connect the console devices to the different user modules.
This step is described in the paragraph User module on page 43.

Connecting user modules to the central module

 Connect the Transmission interfaces of the user modules to the Dynamic Port that is
configured for connecting a user module. In the default, these are ports 1 to 8.
Use a category 5e (or better) twisted-pair cabling for connecting the devices.
NOTE: If required, enable the signalling in the Dynamic Ports modes (see page 15).
The Dynamic Ports for connecting the user modules are marked by green LEDs.
Console side
us In
2 4 6 8
s Out
1 3 5 7
Dynamic Ports
10 12 14 16 18
9 11 13 15 17
Central Module » Installation
20 22 24 26 28
19 21 23 25 27
G&D DVICenter DP32 · 6
CPU side
30 32
Ident.
29 31