The »U2-R-Con« User Module; Package Contents; Required Accessory; Installation - Guntermann & Drunck DVICenter DP32 Installationsanleitung

U2-R-CON « User module
The »U2-R-CON« user module
The U2-R-CON user module transmits USB and RS232 signals from the console to the
U2-R-CPU target module.
NOTE: The U2-CPU target module can be connected only to the USB/RS232 Main
Channel of a stacking matrix switch.
Information about the Stacking mode is given on page 21.

Package contents

 1 × U2-R-CON user module
 1 × power pack (12V/2A)
 1 × power cable

Required accessory

One category 5e (or better) twisted pair cable to connect the target module to the
central module.

Installation

Connecting the console devices

RS232: Connect the serial end device to this interface.
Use a category 5e (or better) twisted pair cable to connect this interface to the
Trans.:
Dynamic Port of the USB/RS232 Main Channel that is assigned to the console.
53 · G&D DVICenter DP32