Choosing A Dmx Channel Mode With 1 Or 3 Channal Occupation; Dmx-Protocol - EuroLite 41604020 Bedienungsanleitung

After having addressed the LED PAR-56 COB 5600K 100W, you may now start operating it via your lighting
controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.

Choosing a DMX Channel Mode with 1 or 3 Channal Occupation

The device has 2 DMX-modes. The Control Board allows you to assign the DMX-Mode.
Setting DMX Mode:

DMX-protocol

3-Channel Mode (default setting)
Control-channel 1 - Dimmer
Value:
000 – 255 Increasing brightness (0 - 100%)
Control-channel 2 - Strobe
Value:
000 – 000 No function
001 – 255 Strobe-effect with increasing speed
Control-channel 3 - Dimmer curves
Value:
000 – 015 Control Board setting dimmer curve
016 – 045 Linear dimmer curve, response characteristics of halogen lamp
046 – 075 Square dimmer curve, response characteristics of halogen lamp
076 – 105 Inverse square dimmer curve, response characteristics of halogen lamp
106 – 135 S-shaped dimmer curve, response characteristics of halogen lamp
136 – 165 Linear dimmer curve, response characteristics of LED
166 – 195 Square dimmer curve, response characteristics of LED
196 – 225 Inverse square dimmer curve, response characteristics of LED
226 – 255 S-shaped dimmer curve, response characteristics of LED
1-Channel Mode
Control-channel 1 - Dimmer
Value:
000 – 255 Increasing brightness (0 - 100%)
Press the MODE button until the display shows CHANNEL.
Press the ENTER button. You can select the DMX channel
mode CH03 or CH01 via the UP or DOWN button. Confirm
your choice by pressing ENTER.
Feature:
Feature:
Feature:
Feature:
22/23 00068630.DOC, Version 1.0