Dmx Mode; Addressing; Dmx Channel Selection : Choosing A Dmx Channel Mode Up To 12 Channal Occupation - EuroLite LED Bar 2 RGB 27/1 Bedienungsanleitung

DMX Mode

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED Bar 2 RGB 27/1 will respond to the controller.
Controlling:
After having addressed the LED Bar 2 RGB 27/1, you may now start operating it via your lighting controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.

Addressing

Press the MODE button until the display shows DMX512 MODE.
Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.

DMX Channel Selection : Choosing a DMX Channel Mode up to 12 Channal Occupation

After having set the desired addresses and pressed ENTER, you can now choose a DMX Channel Mode. (3
CH, 5 CH, 12 CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX Mode.
Please see the following DMX protocol graphics for the respective channel values.
3-Channel Mode:
CH 1
Red (0-100%) Green (0-100%)
(0 - 255) (0 - 255)
5-Channel Mode:
CH 1
Red (0-100%) Green (0-100%)
(0 - 255) (0 - 255)
CH 2 CH 3
Blue (0-100%)
(0 - 255)
CH 2 CH 3
Blue (0-100%)
(0 - 255)
CH 4
Master Dimmer (0-100%)
(0 - 255)
22/24
CH 5
0: On
1 - 5: Sound control (7 colors)
6 - 10: On
11 - 255: Strobe (increasing)
00052050.DOC, Version 1.1