Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
This situation can occur if,
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective.
- the cable or connector is defective or the signal wires are not properly connected with the input connector.
Choosing a DMX Channel Mode with 5 or 7 Channel Occupation
The device has 2 DMX-modes. The Control Board allows you to assign the DMX-Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the
display shows CHND.
You can now set the desired DMX Channel Mode via the UP or DOWN buttons.
Please press the ENTER button to confirm and then the MODE button until the display shows Add.
Please press the ENTER button once again to confirm and then the MODE button to attain the main menu.
Mode:
CHND
7CH (default setting)
DMX-protocol
5 Channel Mode
Channel:
Value:
1
000 – 255
Channel:
Value:
2
000 – 255
Channel:
Value:
3
000 – 255
Channel:
Value:
4
000 – 255
Channel:
Value:
5
000 – 255
7 Channel Mode
Channel:
Value:
1
000 – 255
Channel:
Value:
2
000 – 255
Channel:
Value:
3
000 – 255
Channel:
Value:
4
000 – 255
Value:
5CH
Function:
Red (0 – 100%)
Function:
Green (0 – 100%)
Function:
Blue (0 – 100%)
Function:
White (0 – 100%)
Function:
UV (0 – 100%)
Function:
Red (0 – 100%)
Function:
Green (0 – 100%)
Function:
Blue (0 – 100%)
Function:
White (0 – 100%)
24/26
00077191.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
