Setting The Sound Sensitivity; Dmx Mode; Addressing; Choosing A Dmx Channel Mode With 3 Or 5 Channel Occupation - EuroLite LED PAR-64 Bedienungsanleitung

Setting the Sound Sensitivity:

You can do without a controller as the device features a built-in microphone, which provides automatic sound
control.
Manual adjustements via display as follows:
Mode: Value:
S
S00-S99
You can select the desired sensitivity via the UP or DOWN buttons.

DMX MODE

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PAR-64 RGB Floor/Short will respond to the controller.

Addressing

Press the MODE button until the display shows ADD. You can now set the desired address via the UP or
DOWN buttons.
Setting the DMX Start Address:
Mode:
ADD 001 - 512
Controlling:
After having addressed the LED PAR-64 RGB Floor/Short, you may now start operating it via your lighting
controller.
Note:
The modes of DMX 512 data are shown via the DMX indicator.
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, a point will blink in the first position on the display.
If there is no data received at the DMX-input, the point will not blink.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are not properly connected with the input connector.

Choosing a DMX Channel Mode with 3 or 5 Channel Occupation

The device has 2 DMX-modes. The Control Board allows you to assign the DMX-Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the
display shows CHND.
You can now set the desired DMX Channel Mode via the UP or DOWN buttons.
Mode:
5ch (default setting)
CHND
Sensitivity:
Decreasing sensitivity
Value:
Value:
3ch
21/23 00066216, Version 1.3