Connection With The Mains; Operation; Stand-Alone Mode; Control Board - EuroLite 41604020 Bedienungsanleitung

On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the Slave-Mode on every slave-device (see instructions under Control Board).

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the LED PAR-56 COB 5600K 100W starts running. The display
lights up and you can choose the desired mode via the buttons MODE, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in Stand Alone mode via Control Board and
operating buttons or in DMX-controlled mode via any commercial DMX-controller.
- STAND ALONE-MODE
•
Dimming
•
Slave Mode
•
Dimmer Curves
- DMX MODE

STAND-ALONE MODE

In the stand-alone mode, you can do without a controller. Disconnect the EUROLITE LED PAR-56 COB
5600K 100W from the controller.

Control Board

The Control Board offers several features: you can simply set the starting address or the brightness.
Browse through the main menu by pressing MODE. You can browse through the selection menu and confirm
your choice by pressing ENTER. You can change the selection by pressing UP or DOWN. The functions
provided are described in the following sections.
Dimming:
International
L
N
Press the MODE button until the display shows DIMMER.
Press the ENTER button to select brightness and flash
settings, respectively. You can select the desired brightness
20/23 00068630.DOC, Version 1.0