Sound Control / Sensitivity; Master /Slave; Dmx Mode; Addressing - EuroLite LED MLZ-56 RGB 36x3W Bedienungsanleitung

Once the desired internal program is chosen, press the MODE button again and the display will show
OH/OFF. ON is with Zoom effect, OFF is without Zoom effect.

Sound Control / Sensitivity

Press the MODE button until the display shows S. You can select the desired sensitivity via the UP or
DOWN buttons.
Mode:
S
S00 - S99 (S50 default)

Master /Slave

Press the MODE button until the display shows Add. Set the DMX start address 001 on every slave-device.

DMX MODE

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED MLZ-56 RGB 36x3W will respond to the controller.

Addressing

Press the MODE button until the display shows Add. You can now set the desired address via the UP or
DOWN buttons.
Setting the DMX Start Address:
Mode:
Add 001 - 512
Controlling:
After having addressed the LED MLZ-56 RGB 36x3W, you may now start operating it via your lighting
controller.
Note:
It's necessary to insert the XLR termination plug with 120
proper transmission on the DMX data link.

Choosing a DMX Channel Mode with 4 or 6 Channal Occupation

The device has 2 DMX-modes. The Control Board allows you to assign the DMX-Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the
display shows 6ch.
In case you would rather select the 4-channel mode, press the DOWN button in order to choose the 4ch
setting.
Mode:
6ch (default setting)
Value
Value:
Value:
4ch
in the last lighting in the link in order to ensure
21/23 00055936.DOC, Version 1.1