Sound Control/Sensitivity; Dmx Mode; Addressing; Choosing A Dmx Channel Mode With 4 Or 6 Channal Occupation - EuroLite LED ML-30 QCL 7x8W Bedienungsanleitung

Sound Control/Sensitivity

Press the MODE button until the display shows S. You can select the desired sensitivity via the UP or
DOWN buttons.
Mode:
S S00 - S99 (S50 default setting)

DMX MODE

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED ML-30 QCL 7x8W will respond to the controller.

Addressing

Press the MODE button until the display shows Add. You can now set the desired address via the UP or
DOWN buttons.
Setting the DMX Start Address:
Mode:
Add 001 - 512
Controlling:
After having addressed the LED ML-30 QCL 7x8W, you may now start operating it via your lighting
controller.
Note:
It's necessary to insert the XLR termination plug with 120
proper transmission on the DMX data link.

Choosing a DMX Channel Mode with 4 or 6 Channal Occupation

The device has 2 DMX Modes. The Control Board allows you to assign the DMX Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the
display shows 6ch.
In case you would rather select the 4-channel mode, press the DOWN button in order to choose the 4ch
setting.
Mode:
6ch (default setting)
Value
Value:
Value:
4ch
in the last lighting in the link in order to ensure
22/24 00060603.DOC, Version 1.1