Addressing; Choosing A Dmx Channel Mode With 3 Or 5 Channel Occupation; Dmx-Protocol - EuroLite LED BAR-12 RGB Bedienungsanleitung

Addressing

Press the MODE button until the LED screen shows Add. You can now set the desired address via the UP
or DOWN buttons.
Setting the DMX Start Address:
Mode:
Add 001 - 512
Controlling:
After having addressed the LED BAR-12 RGB 12x1W, you may now start operating it via your lighting
controller.
Note:
It's necessary to insert the XLR termination plug with 120
proper transmission on the DMX data link.

Choosing a DMX Channel Mode with 3 or 5 Channel Occupation

The device has 2 DMX-modes. The LED screen allows you to assign the DMX-Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the LED
screen shows 5ch.
In case you would rather select the 3-channel mode, press the DOWN button in order to choose the 3ch
setting.
Mode:
5ch (default setting)

DMX-protocol

5 Channel Mode
Channel: Value:
1 000 – 255
Channel: Value:
2 000 – 255
Channel: Value:
3 000 – 255
Channel: Value:
4 000 – 255
Channel: Value:
000 – 000
001 – 005
5
006 – 010
011 – 255
3 Channel Mode
Channel: Value:
1 000 – 255
Value:
Value:
3ch
Function:
Red (0 – 100%)
Function:
Green (0 – 100%)
Function:
Blue (0 – 100%)
Function:
Dimmer (0 – 100%)
Function:
ON
Sound Control (7 colors)
ON
Strobe (increasing)
Function:
Red (0 – 100%)
in the last lighting in the link in order to ensure
22/23 00058443.DOC, Version 1.1