Dmx Mode; Addressing; Choosing A Dmx Channel Mode With 3 Or 5 Channel Occupation - EuroLite LED PAR-56 Bedienungsanleitung

Not all functions on the universal remote control are applicable to this device.
Button
Blackout LEDs off
SPR Internal programs; via „+/-„ the 6 internal programs can be chosen
FL Flash on or off; via „+/-„ the speed can be regulated
SP Speed; via „+/-„the color change and color fade speed can be regulated
D

DMX mode

SA Sound controlled mode
SL Master/Slave mode
S Setting DMX address; via 1, 2, 3, 4, 5, 6, 7, 8, 9 the DMX addresses can be set
R (red)
G (green) Static colors; via „+/-„ the brightness can be regulated
B (blue)
For example, to set the DMX starting address 245 via IR remote, please proceed as follows:
Press S for setting the DMX address. Press 2, followed by 4 and 5.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PAR-56 COB RGB 25W will respond to the controller.

Addressing

Press the MODE button until the display shows Add. You can now set the desired address via the UP or
DOWN buttons.
Setting the DMX Start Address:
Mode:
Add 001 - 512
Controlling:
After having addressed the LED PAR-56 COB RGB 25W, you may now start operating it via your lighting
controller.

Choosing a DMX Channel Mode with 3 or 5 Channel Occupation

The device has 2 DMX Modes. The Control Board allows you to assign the DMX Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the
display shows 5CH.
In case you would rather select the 3-channel mode, press the DOWN button in order to choose the 3CH
setting.
Mode:
5CH (default setting)
Value:
Value:
3CH
Parameter
25/27 00088210.DOC, Version 1.1