Completing The Charging Process; Initial Use; Adding Staples; Functions - Parkside PAT 4 B2 Originalbetriebsanleitung

Completing the charging process

Disconnect the charger
Disconnect the charger
on the product.
Note: The product cannot be used whilst charging. It is normal
for the handle to warm up slightly whilst charging.

Initial use

Adding Staples

Set the On / Off switch
the product.
Turn the product over.
Squeeze the release button
Pull back on the pusher
Add staples to the magazine
After adding staples, slide the pusher
zine is fully closed. Release the release button
4
and lock into place for the magazine
Note: Use the window on the fill indicator
zine is empty.
4

Functions

Stapling
Set the On / Off switch
Press the safety contact
Squeeze the trigger
piece to drive a staple into it.
Set the On / Off switch
product off.
from the power source.
7
from the micro-USB charging socket
7
to the "0" position before working on
8
(see Fig. A).
3a
(see Fig. A).
3
(see Fig. B).
4
to the "I" position to switch the product on.
8
a few millimetres into the work piece.
6
whilst holding the product against the work
1
to the "0" position to switch the
8
in again until the maga-
3
. It must click
3a
to be closed correctly.
4
to see if the maga-
5
2
GB 17