Sto/Sbc Produced By Situation (Switch Mode = 10) - Kübler SMC1 Bedienungsanleitung

STO/SBC Produced by Situation (Switch Mode = 10)

11.12.
If an STO should e.g. be triggered by over speed, a second feedback output,
configured as over speed can be used as enable input (parameter "Matrix
XXXX"). One of the two functions requires a lock function.
Relevant Parameters
Switch Mode XXXX
Matrix XXXX
MIA-Delay XXXX
MAI-Delay XXXX
Lock Output
Output Mode
*IN* Function
*IN* Config
Input Mode
GPI Err Time
Relevant input functions
Enable (Function: 21)
Clear lock function (function:
1-6)
Doc. # R60719
Remark
= 10
feedback output
= 0 (can also be set according to need)
= 0 (can also be set according to need)
for lock function use only range 0-31
homogenous or inverse (affects the Safety Integrity
Level SIL)
input function
switching behavior (dynamically, statically)
input configuration (affects the Safety Integrity Level
SIL)
Max. permissible delay time during illegal conditions
Remark
activates the function
when lock function is active only
Monitoring Functions
EN - 95