Handling And Start-Up; Display Indications And Symbols - VOLTCRAFT VC1008 Anleitung

6.

HANDLING AND START-UP

Display indications and symbols

Stands for "relative measurement" (= reference measurement)
∆
AUTO Stands for "automatic measuring range selection"
OL Stands for "overload"; value is outside measuring range
Low battery symbol; please replace battery immediately to avoid measurement errors!
Symbol for diode test
Symbol for acoustic continuity test
Clock symbol indicating active automatic switch-off (Auto Power OFF)
Symbol indicating active display backlight
Display of the measured value as an analog bar graph display
0 40
TRUE RMS Indicator for true RMS (AC or AC+DC-coupled)
AC AC voltage or current
DC DC voltage or current
mV Millivolt (exp-3)
V Volt (unit of electrical potential)
A Ampere (unit of electrical current)
mA Milliampere (exp-3)
µA Microampere (exp-6)
Hz Hertz (unit of frequency)
kHz Kilohertz (exp3)
MHz Megahertz (exp6)
Ω Ohm (unit of electrical resistance)
kΩ Kiloohm (exp3)
MΩ Megaohm (exp6)
nF Nanofarad (exp-9; unit of electrical capacitance)
40