Transport, Packaging And Storage; Transport; Packaging; Storage - WIKA Wally Box III CPH7600 Betriebsanleitung

5 Transport, packaging and storage

5 Transport, packaging and storage
5.1

Transport

GB
Check hand-held pressure calibrator for any damage that may have been caused by
transport. Obvious damage must be reported immediately.
5.2

Packaging

Do not remove packaging until just before use.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
5.3

Storage

Permissible conditions at the place of storage:
Storage temperature: -20 ... +60 °C
■
Humidity: 35 ... 85 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable atmospheres
■
Store the hand-held pressure calibrator in its original packaging in a location that fulfills the
conditions listed above. If the original packaging is not available, pack and store the hand-held
pressure calibrator as described below:
1. Wrap the hand-held pressure calibrator in an antistatic plastic film.
2. Place the hand-held pressure calibrator, along with shock-absorbent material, in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag, containing a desiccant,
inside the packaging.
18 WIKA Operating Instruction, Model CPH7600