Faults; Dismounting, Return And Disposal - WIKA Wally Box III CPH7600 Betriebsanleitung

8 Faults / 9 Dismounting, return and disposal

8 Faults

Display Reason
Low battery power, device will only
work for a short while longer.
OL Well above or below the limits of
the measuring range
-OL
Battery flat
No display or
System error
strange symbols,
device is not
Technical fault
responding to input
CAUTION!
If faults cannot be eliminated by means of the measures listed above, the hand-held
pressure calibrator must be shut down immediately, and it must be ensured that
pressure and/or signal are no longer present, and it must be prevented from being
inadvertently put back into service. In this case, contact the manufacturer. If a return is
needed, please follow the instructions given in chapter "9.2 Return".

9 Dismounting, return and disposal

9.1 Dismounting
Only disconnect test- and calibration installations once the system has been depressurised!
9.2 Return
WARNING!
Strictly observe when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazardous
substances (acids, bases, solutions, etc.).
When returning the instrument, use the original packaging or a suitable transport
package.
To avoid damage:
1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument, along with the shock-absorbent material, in the packaging. Place shock-
absorbent material evenly on all sides of the shipping box.
3. If possible, place a bag, containing a desiccant, inside the packaging.
4. Label the shipment as transport of a highly sensitive measuring instrument.
WIKA Operating Instruction, Model CPH7600
Measures
Charge rechargeable battery
Check: is the pressure within the permissible
measuring range of the sensor?
Charge rechargeable battery
Switch off the CPH7600, wait for a short
period of time, switch on again
Return to manufacturer for repair
GB
37