Changing Batteries In The Wireless Alarm Control Centre; Changing Batteries In The Wireless Door/Window Sensors; Changing Batteries In The Wireless Movement Sensor; Changing Batteries In The Remote Control - Conrad 751364 Bedienungsanleitung

17. Changing Batteries in the Wireless Alarm
Control Centre
• Remove both screws from the battery cover at the back of
the housing.
• Take out the battery pack (pull out connector).
• Attach a new rechargeable battery pack (6V, 1300 mAh,
NIMH) and place it in the battery compartment.
• Replace the battery compartment cover and reattach the
two screws for the battery compartment cover.
Note that the sabotage contact will be acti-
vated when the rechargeable battery cover is removed.
18. Changing Batteries in the Wireless Door/
Window Sensors
• Open the housing of the wireless door/window sensor.
• Remove the battery from within.
• Place a new „CR2032" type battery in the correct polarity (plus = top) in the battery holder.
• Close the housing of the wireless door/window sensor.
19. Changing Batteries in the Wireless Movement
Sensor
• Remove the screw from the battery compartment cover at the back of the housing.
• Remove the cover of the battery compartment.
• Remove the battery from within.
• Insert a new 9 V block battery.
• Slide back on the battery compartment cover.
• Attach the screws back on the battery compartment cover.

20. Changing Batteries in the Remote Control

• Remove both screws at the back of the housing.
• Remove the battery from within.
• Insert a new type „23AE 12V" battery in the correct polarity.
• Place the housing back together and reattach the two screws on the back of the housing.
89