Mute Function; System Status Report - Conrad 751364 Bedienungsanleitung

There is one condition that the main unit will respond to movement sensor, that is programming the
movement sensor in a Bypass Zone. If a movement sensor is in a Bypass Zone, the main unit will
respond to the movement sensor when the system is disarmed. Please refer to section 14.3 Alarm
Zones (Bypass Zones) for more information.

11.1.2 Mute Function

You can mute the sensor activation beep tone when the alarm is in disarmed status. There are three
ways to do this:
a) „MUTE" button (5)
Press the „MUTE" button (5) as soon as a sensor has been activated. The beep will no longer be
emitted for this sensor. Note, however, that as soon as another sensor is activated, the beep will be
emitted again.
b) „Mode selection switch" (13)
Place the „Mode selection switch" (13) in position II in order to deactivate the beep tone for all zones
and thus all sensors.
„Mode selection switch" (13) position I = beep tone is activated
„Mode selection switch" (13) position II = beep tone is deactivated
c) Activate the automatic mute function.
Please note Chapter „14.2 Automatic Mute Function".

11.2 System Status Report

You can hear the system status by pressing the „STATUS" button (4).
As soon as the „STATUS" button (4) is pressed, the following information is given:
- System activated (armed) or system deactivated (system disarmed)
- Activated zones and sensors
- Sensors with low battery charge
- "Phone Line Error" (check the cable connection between the internal alarm dialler and the telephone
line socket)
67