Overview Table - Conrad 751364 Bedienungsanleitung

Follow the following instructions in order to set the desired setting for the corresponding acoustic alarm
sounding:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button 5
4 Alarm sounding via beep tone:
Press the button 1, 2, 3, 4 or 5
(depending on which memory you
wish to allocate alarm sounding via
beep tone).
5 Alarm sounding via internal siren:
Press the button 6, 7, 8, 9 or 0
(depending on which memory you
wish to allocate alarm sounding via
internal siren).
6 Press „PROG" (12).

Overview table:

This illustrates which button must be pressed in step 4 or 5 of the table above:
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Function
You enter the programming
mode.
You enter the programming
mode for setting the acoustic
alarm sounding.
The settings are saved and the
programming mode for setting the
acoustic alarm sounding is exited.
Alarm sounding via beep tone
Button 1
Button 2
Button 3
Button 4
Button 5
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
As soon as you enter the
programming mode, the „zone
status LEDs" (1) light up or flash
Flashing = alarm sounding via
beep tone, lit continuously = alarm
sounding via internal siren.
Please also note the following
overview table.
Please also note the following
overview table.
Alarm sounding via internal siren
Taste 6
Button 7
Button 8
Button 9
Button 0
75