Conrad 751364 Bedienungsanleitung Seite 84

First step: Programming the wireless switching module to the alarm system.
Proceed as follows to programme the wireless switching module to the alarm system:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button 4
4 Press the button 1, 2, 3, 4 or 5
(depending on which memory
position you wish to use).
5 Activate the wireless switching
module
** Explanation of „zone status LEDs" (1) from step 3 in the table above:
„Zone status LED" (1)
Does not light up
Flashes twice
Flashes once
Flashes once and then twice
Function
You enter the programming
mode.
You enter the programming
mode for programming in a
wireless switching module.
A maximum of five wireless
switching modules can be
programmed.
A voice message confirms
successful programming.
Explanation
No wireless switching module has been programmed to this memory position yet.
A wireless switching module has already been programmed to this memory position.
if you programme a further wireless switching module to this memory position, the
previous one will be overwritten.
A remote control has already been programmed to this memory position. A wireless
switching module can, however, still be programmed to this zone. The programmed
remote control will not be overwritten.
A wireless switching module and a remote control have both already been pro-
grammed to this zone. If you add another wireless switching module to this zone,
the previous wireless switching module will be overwritten.
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
As soon as you enter the
programming mode, the „zone
status LEDs" (1) light up or flash.
** Please see the following table
for further explanation
The settings are saved and the
programming mode for
programming in wireless
switching modules is exited.
83