Conrad 751364 Bedienungsanleitung Seite 60

• Connect the telephone line to the „LINE" connection (15) on
the alarm system.
• If the telephone line which the alarm system is connected to
is already occupied by a telephone, you can connect this
phone to the „PHONE" connection (14).
• Replace the lid of the rechargeable battery compartment.
• Reinsert and tighten the attachment screws you removed
previously.
Please note, as soon as the rechargeable bat-
tery compartmentcover is put in place, the
sabotage contact is depressed. Loosening
the rechargeable battery compartment cover
again will trigger the internal alarm.
Thus, please ensure that the rechargeable
battery compartment cover is not loosened
again before the screws are tightened to
secure the cover, as this will trigger the
sabotage contact.
• The wall mounting of the alarm control centre is carried out with two screws and wall plugs (supplied
with the system).
First attach two screws horizontally level at a distance of 180mm from one another at the chosen mount-
ing location. Depending on the condition of the wall, you will need to drill two holes and insert wall plugs.
Be careful not to accidentally damage any electric cables, gas or water pipes, there
is a risk of injury or death!
• Then insert and tighten the screws with a suitable
screwdriver. Ensure that the distance between the bottom of
the screw head and the wall is approximately 3mm, see the
figure on the right.
• The alarm control centre is then hung on the two screws with
the two slits on the back of the device.
• Connect the plug-in power supply to a 230 V/AC 50 Hz
power socket.
After successful installation and connection, the „PWR" (7), „ARM" (8) and „PROG" (9) LEDs on the front
of the device begin to flash.
59