Sensor Allocation Instructions - Conrad 751364 Bedienungsanleitung

14.5.1 Sensor Allocation Instructions

As previously mentioned, up to ten sensors can be programmed in. There are five zones available for this.
Each zone can have two wireless sensors programmed to it. The four previously mentioned individual settings
options (Chapter 14.5 Programming Recognition of New Sensors) are zone dependent. So if you programme
two sensors to one zone, both sensors will have the same preprogrammed individual settings options.
Example:
You have programmed two sensors to zone 1. Both sensors, zone 1 sensor 1 and zone 1 sensor 2 have
the same preprogrammed individual settings options.
It is not possible to have allocate zone-dependent individual settings options to zone 1 sensor 1 or to
zone 1 sensor 2, to zone 2 sensor 1 or zone 2 sensor 2 etc.
The following things are to be taken into account when planning which sensor should be programmed to
which zone:
a) Consider all four zone-dependent individual settings options and then decide whether you wish to
activate or deactivate any of them for a zone.
b) If you do not wish to apply any zone dependent settings options to any zones (and thus use the
factory settings) you can proceed directly to programming new sensors (Chapter „14.5.2
Programming in Sensors").
c) If you wish to apply any zone dependent settings please note the following overview table. Fill out the
overview table according to your thoughts.
Overview table:
Sensor 1
Memory
position
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Example of a completed table:
Sensor 1
Memory
position
Zone 1 Front door
Zone 2 Movement
sensor /
kitchen
Zone 3 Back door
Zone 4 Movement
sensor
hallway
Zone 5 Water level
bathroom
80
Sensor 2 Zone dependent individual settings options
Memory Acoustic alarm
position sounding
Beep tone/siren
Beep tone/siren
Beep tone/siren
Beep tone/siren
Beep tone/siren
Sensor 2 Zone dependent individual settings options
Memory Acoustic alarm
position sounding
Front Beep tone
window
Beep tone
Beep tone
Beep tone
Siren
Automatic mute
function Event
yes/no Deactivated/On/Off
yes/no Deactivated/On/Off
yes/no Deactivated/On/Off
yes/no Deactivated/On/Off
yes/no Deactivated/On/Off
Automatic mute
function Event
no On
no deactivated
yes deactivated
no deactivated
no deactivated
Alarm
sounding
yes/no
yes/no
yes/no
yes/no
yes/no
Alarm
sounding
no
no
no
yes
no