Remote Slave Flash Mode Settings; Setting The Slave Channel - Metz Mecablitz 64 AF-1 digital -Sony Bedienungsanleitung

10.2.1 Remote slave flash mode settings

• Switch on the flash unit with the
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. TTL flash mode).
TTL
• Press the displayed mode of operation on
the touch display as many times as it takes
0.8- 9.0 m
for the display for selecting the mode of
M-
operation to appear.
35 m
Zoom
m
EV
O
MODE
• Press the
REMOTE MASTER
touch display and select
REMOTE SLAVE
SERVO
• Press the
k
the touch display.
p
q
REMOTE RMT Ch
SLAVE
2 1
M-
Zoom 24 m
Remote slave mode is set.
m
P
In addition, the selected slave group (e.g.
1/1
RMT) and the remote channel (e.g. CH 1) are
displayed.
186
sensor buttons on the
REMOTE SLAVE
.
REMOTE SLAVE
s ensor button on

10.2.2 Setting the slave channel

RMT Ch
REMOTE
• Press the sensor button on the touch display
SLAVE 2 1
for the channel group (e.g.
M-
The window for selecting the channel and
Zoom 24 m
m
group appears.
O
SLAVE
• Press the sensor buttons on the touch
CHANNEL
display for the channel
GROUP
O
CHANNEL
• Press the
CHANNEL 1
touch display and select the desired
CHANNEL 2
channel.
CHANNEL 3
• Press the selected channel on the touch
display.
p
q
RMT Ch
REMOTE
SLAVE
2 2
The setting will take effect immediately.
"CH2" appears on the display.
M-
Zoom 24
P
1/1
RMT I CH1
).
CHANNEL
.
sensor buttons on the