Remote Slave Flash Mode; Remote Slave Flash Mode Settings - Metz Mecablitz 52 AF-1 Sony digital Bedienungsanleitung

10.2 Remote slave flash mode

The flash unit supports the wireless remote
system in slave flash mode and is compatible
with the Sony system. At the same time, one
or more slave flash units can be remotely
controlled from one master flash unit on the
camera (e.g. mecablitz 52 AF-1 S digital).
A slave flash unit can be assigned to two of
three possible slave groups (RMT, RMT2).
The master flash unit can control all of these
slave groups simultaneously and at the same
time take the settings for each slave group
into account.
So that multiple remote systems in the same
room do not interfere with one another,
there are four independent remote channels
available (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
k
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode.
Depending on the camera model, the came-
ra's internal flash unit can also function as
master flash unit. Please consult the respec-
tive camera operating instructions for further
tips on setting the master flash unit.
164

10.2.1 Remote slave flash mode settings

• Switch on the flash unit with the
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. M flash mode).
• Press the displayed mode of operation on
TTL
the touch display as many times as it takes
-7,9 m
0,7
for the display for selecting the mode of
m
Z operation to appear.
35 F4.0
OOM
m
EV
INFO
MASTER
• Press the
touch display and select "SLAVE".
SLAVE
SERVO
• Press the
REMOTE touch display.
RMT CH
SLAVE
1
Remote slave mode is set.
Z
35 mm
OOM
INFO 1/1
In addition, the selected slave group (e.g. A)
and the remote channel (e.g. RMT) are dis-
played.
sensor buttons on the
SLAVE
sensor button on the