Spotbeam Mode - Metz Mecablitz 64 AF-1 digital -Pentax Bedienungsanleitung

Setting the flash frequency (f(Hz))
STROBO
• Press the sensor button on the touch
M-
2,2m
m
35
Zoom
m display for the flash frequency
4 10
N f(Hz)
P
1/16
f (Hz) O
• Press the
touch display and select the desired fre-
7
quency of flashes.
8
9
p
q
+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
• Press the sensor button on the touch
STROBO
k
display for the desired frequency of flashes
in the example
M-
2,2m
m
35
Zoom
The setting will take effect immediately.
m
4 8 The valid distance to the set parameters is
N f(Hz)
shown on the display. The distance value dis-
P
played can be adjusted to the distance from
1/16
the subject by changing the f-stop or the par-
tial light output.
The aperture and ISO values are not shown
on the display in Strobe flash mode!
+
The secondary reflector is not supported in
the Stroboscopic flash mode.
180
f (Hz)
.
sensor buttons on the
8
.

7.7 SPOTBEAM mode

In the SPOTBEAM mode, the AF measuring
beam can be used to focus on a subject at
low ambient light level without firing a flash
when the shot is taken.
There is no flash-ready indicator in
SPOTBEAM mode and no exposure control
indicator in the camera viewfinder. The came-
ra is not set to its sync speed and behaves as
though there were no flash unit connected.
+
SpotBeam mode is only activated when the
flash unit is switched on and is flash-ready
(check the flash-ready indicator on the flash
unit!).
When the camera shutter is released, no
flash is fired. Please read the notes on the AF
measuring beam in chapter 11.8 AF-BEAM.