Loading Paper In The Unit; Loading Paper - Sony UP-897MD Gebrauchsanweisung

Loading Paper in the
Unit
Notes
• Before loading paper in the unit, see "Notes on storing
and handling paper" (page 42).
• Always handle paper carefully when loading to avoid
adversely affecting the quality of the printouts. Never
bend or crease the paper and never touch the printing
surface with your fingers. Fingerprints perspiration
can blur printing.
• Do not use any paper other than UPP-110S/110HD/
110HG paper. (page 42)
• Be sure to set the "MEDIA" menu item to the paper to
be used. You can confirm the media currently selected
on the LCD. (page 47)

Loading Paper

Caution
A paper cutter is mounted with the unit. When loading
paper, be careful not to touch the paper cutter. Touching
the paper cutter may cause injury.
1
Press the power ON/OFF switch to turn the unit on.
When paper is not loaded yet, the back light on the
LCD lights in umber and the message "EMPTY" is
displayed.
2
Press the OPEN button to open the paper door.
3
Remove the label from the leading edge of the
paper, pull out about 15~20 cm (about 6~8 in.) of
the paper, and then set the paper roll in the paper
tray.
Note
To avoid exposing the paper to dust, dirt, etc.
always handle it carefully when removing from its
package and loading it in the unit. Paper exposed to
dirt or dust cannot be used for printing.
Load the paper with the printing side (heat
sensitive side) up. Printing is not possible if the
paper is reversed.
Remove label and pull
out 15 to 20 cm (about 6
to 8 inches).
43

Loading Paper in the Unit