Registering Menu Settings - Sony UP-897MD Gebrauchsanweisung

5
Display "DI:REV" in the LCD by turning the jog
dial up or down, and then press the jog dial.
"DI:REV" is registered as the printing direction.
Note
If about 20 seconds elapse without making any
menu operation after you have displayed the menu
item or setting, the display returns to "READY" on
the LCD and the unit exits the menu mode. In such
a case, the setting of "DIR" is not changed.
To cancel the setting
1
Display "BACK" by turning the jog dial in step 5.
2
Press the jog dial.
The display on the LCD returns to "DIR."
To continue menu operations
Make settings by repeating steps 3 to 5.
To end the menu operation
1
Display "BACK" by turning the jog dial after
performing the operation of step 5.
2
Press the jog dial.
The display returns to "READY."
The unit exits the menu mode.
Menu lock function
If the message "LOCK" is displayed and you hear the
alarm sound when you press the jog dial, the jog dial is
disabled because the menu operation function is locked.
50
Adjustments and Settings Using the Menu
If you want to perform a menu operation, contact the
nearest authorized dealer.

Registering Menu Settings

You can store up to three sets of settings made using the
menu, and you can load the desired setting when needed.
The unit retains these settings even if you turn off the
power.
Note
When you use the unit for the first time after you
purchase it, factory settings are registered in all three of
the stored selections.
Registering new settings
1
Make all of the required settings.
2
Display "SAVE" by turning the jog dial, and then
press the jog dial.
3
Display the desired number by turning the jog dial,
and then press the jog dial, again.
The settings made in step 1 are registered in the
number selected in step 3.
Loading the desired settings
You can load the desired settings and make printouts
with the loaded settings.
1
Confirm that "READY" is displayed on the LCD,
and press the jog dial.
2
Display "LOAD" by turning the jog dial, and then
press the jog dial again.
3
Display the number corresponding to the desired
settings, and then press the jog dial.
Settings corresponding to the number selected in
step 3 are loaded.
When you change the loaded settings
The unit operates according to the changed settings. In
this case, the unit operates according to these settings
until you load another set of settings, even if you turn off
the unit. When you load another group of settings, the
settings loaded previously are cleared.
To retain previously loaded settings
Example: Settings registered as "SA:1" are loaded and
settings are to be changed. To retain the original settings
of "SA:1" and to register the new settings as "SA:2,"
proceed as follows.