Rear Panel - Sony UP-897MD Gebrauchsanweisung

G
COPY button (52)
Prints another copy of the previous printout.
You can make only one copy each time you press
this button regardless of the print quantity set using
the menu.
H
PRINT button
Prints the image currently displayed on the video
monitor. The image displayed when you press the
PRINT button is stored in memory.
I
OPEN button (43, 52)
Press to open the paper door. While a print job is in
progress, press to cancel the print job.
J Paper cutter
Cuts the paper as each image is printed.

Rear Panel

A
REMOTE connector (42)
Connects the RM-91 remote control unit or the FS-
24 foot switch for controlling print operation from
a distance.
B 75 Ω select switch
ON: When nothing is connected to the VIDEO
OUT connector, set the switch to this position.
OFF: When a video monitor or other video
equipment is connected to the VIDEO OUT
connector, set the switch to this position.
C t VIDEO IN (input) connector (BNC type)
Connect to the video output connector of the video
equipment.
D T VIDEO OUT (output) connector (BNC type)
Connect to the video input connector of the video
monitor. The output signal depends on the setting of
the "VIDEO" item of the menu.
E - AC IN connector
Use a proper power cord for your local power
supply.
Refer to "Warning on power connection" on page
38 and "Warning on power connection for medical
use" on page 38.
F
Equipotential terminal
Used to connect to the equipotential plug to bring
the various parts of a system to the same potential.
Refer to "Important safeguards/notices for use in
the medical environments" on page 34.
Location and Function of Parts and Controls
41