Loading The Paper - Sony UP-D2550S Gebrauchsanweisung

Before Printing (continued)

Loading the Paper

18
Operation
To load paper, follow the procedure below. Be careful not to touch the printing
surface.
Notes
• Use only ink ribbon cartridge and paper that are designed for use with this
printer. Failing to do so is likely to result in unsatisfactory printing or
malfunctions.
• When you load paper while you are operating the printer, do not turn off the
printer power. Turning off the power will cause the image stored in memory to
be lost.
1
Open the front panel by pulling the front panel top towards you.
2
Push the part marked with PUSH on the paper tray.
The paper tray pops out.
3
Place the paper in the paper tray.
Notes
• The amount of paper that the paper tray holds depends on the paper in use.
When adding paper to a partly full tray, be careful that the total number of
sheets does not exceed the limit. If you exceed this limit, paper jams may
occur.
The limit is the amount of paper contained in one printing pack.
For detailed information on the maximum amount of paper that the paper tray
can hold, see "Ink Ribbon Cartridge and Paper" page 22.
• Do not place different types of paper in the tray. Doing so may cause paper
jams to occur.
• Load the paper so that it lays flat in the paper tray. If the paper is curled, it
will overflow from the paper tray and the printing position may shift. If this
happens, load fewer sheets in the paper tray.