Operation; Loading The Paper And Ink Ribbon - Sony UP-DR100 Gebrauchsanweisung

Operation

Loading the Paper and
Ink Ribbon
Before using the printer for the first time, confirm that
you have all of the accessories, and assemble them as
described on page 34.
After connecting the printer as described on page 36,
load the paper and ink ribbon following the steps below
to prepare for actual printing.
These steps are not required every time you print, but
only as necessary.
Notes
• The printing pack contains an ink ribbon and one
paper roll. Use the ink ribbon and the paper roll in the
carton as a set. Do not mix with other varieties of
ribbon or paper. ("Ink Ribbon and Paper" on page 51.)
• Each printing pack allows you to print the following
number of sheets.
Print pack UPC-R35
Printing 400
capacity
×
Print size 89 127 mm
×
3.5 5 inches
• The number of printouts that can be printed may not
be guaranteed if you replace the ink ribbon and paper
before the ink ribbon and paper run out.
• Place the paper roll vertically with flanges facing up
and down. If you place the paper roll horizontally, the
paper may roll around and fall. This may cause an
injury.
Flanges
UPC-R46 UPC-R57
350 205
× ×
102 152 mm 127 178 mm
× ×
4 6 inches 5 7 inches
• Hold the right and left flanges of the paper roll so that
you do not drop it, because it is heavy. Dropping may
result in an injury and may cause accumulation of dust
on the paper. Any dust on the printing surface will
result in poor printout quality.
• A built-in IC chip is located around one side of the
Be careful not to hurt the IC Be careful not to hurt the IC
Be careful not to hurt the IC Be careful not to hurt the IC
flange of the paper roll.
seal or give it a shock. seal or give it a shock. seal or give it a shock. seal or give it a shock.
If you do, you may not be able
to use the ink ribbon any more.
Hold the right and left flanges with both hands.
• Do not detach the blue and pink spools of the ink
ribbon until you start loading the ink ribbon
• A built-in IC chip is located around one side of the
Be careful not to hurt the IC seal or Be careful not to hurt the IC seal or Be careful not to hurt the IC seal or Be careful not to hurt the IC seal or
pink spool.
give it a shock. give it a shock. give it a shock. give it a shock.
If you do, you may not be able to use
the ink ribbon any more.
IC seal in which the IC
chip is built
Blue spool

Loading the paper and ink ribbon

When you use the printer for the first time, load the
paper and ink ribbon.
For detailed information on how to remove the paper
and ink ribbon, see page 41.
Note
Be careful that your fingers or clothes don't get caught
in the front door or front door catch.
Loading the Paper and Ink Ribbon
Pink spool
37