Loading The Paper Roll And Ink Ribbon; Unlocking The Ribbon Door - Sony SnapLab UP-CR25L Bedienungsanleitung

Shutdown
1
Complete any pending operations, and then bring up
the Start Guide screen.
2
Verify that no memory card is inserted in any of the
front-side memory card slots of the unit. Then turn off
the POWER switch.
Note
After turning off the unit, wait at least 5 seconds before
turning it on again.
Loading the Paper Roll
and Ink Ribbon

Unlocking the Ribbon Door

The ribbon door is locked for safety when the unit is turned
on. To unlock the door, proceed as follows and display the
administration screen.
1
Turn on the power and start the unit.
The Start Guide screen appears.
If an ink ribbon or paper roll is not loaded, an error
message appears.
2
Touch the top left corner of the screen twice in
succession.
The password entry screen appears.
3
Enter the administrator password using the numeric
keypad, and touch [OK].
(The factory default setting for the password is
"9999.")
The administration screen appears.
When the administration screen appears, the ribbon
door will unlock.

Loading the Paper Roll and Ink Ribbon

25