Shutting Down En; Storing The Device; Maintenance And Care En - Kärcher NT 80/1 B1 M Originalbetriebsanleitung

The control lamp can light up occasion-
–
ally during normal operation (e.g., while
working with a floor nozzle), if the air
volume comes down (cross-sectional
reduction) causing a low pressure.
There is no defect in this case; only an
–
indication that, as specified above, the
air volume has reduced and the low
pressure has increased.
Shutting down
Turn the unit off (position "0").
Rinse out the accessory parts with wa-
ter if necessary and dry them.
Tap the cartridge filter and rinse inside
and outside with running water. Place
the cartridge filter with the rubber side
facing downwards onto a storage place
and leave it to dry or place the suction
head onto the floor and let the suction
turbine run. The air flow dries the car-
tridge filter. If the cartridge filter is too
dirty or damaged, then it is necessary to
replace it with a new one.
Note
Empty the vaccum cleaner after every use
and clean only when required.
Empty the container.
Vacuum and wipe the appliance inside
and outside.
Place the appliance in a dry room and
secure it from unauthorized use.
While vacuuming the appliance, use at
least one vacuum cleaner of the same
or higher classification.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
When transporting in vehicles, secure the
appliance according to the guidelines from
slipping and tipping over.
During the transport and maintenance of
the appliance the extraction opening is to
be closed with the connection socket.

Storing the device

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Maintenance and care
Warning
First remove the mains plug before doing
any job on the vacuum cleaner.
Dust extracting machines are safeguards
for the prevention or elimination of hazards
defined in the regulations of BGV A1.
In order to carry out maintenance work,
–
the user must disassemble, clean and
service the unit, in so far as this is pos-
sible without endangering maintenance
personnel and other persons. Suitable
precautions include decontamination
before the unit is disassembled. Pre-
cautions must be taken for local filtered
forced air ventilation at the place where
the unit is dissassembled, the cleaning
of the maintenance surface and suita-
ble protection of the personnel.
The outside of the unit should be
–
cleaned thoroughly and any harmful
substances removed. Alternatively, a
sealed coating may be applied before
the unit is removed from the danger ar-
ea. All unit parts are to be considered
contaminated when they are removed
from the danger area.
6
-
EN
Transport
13