Call Through - Teldat elmeg hybird 300 Benutzerhandbuch

Teldat GmbH
Setting up/deleting follow-me externally

4.2.24 Call Through

This operation is only possible from an external telephone.
hybird 300 / hybird 600
Lift the receiver.
Press the * button or # button (Set up / delete follow-me).
Dial the code.
Dial the internal phone number from which you want to forward calls to yourself.
Confirm your input with the # key.
You hear the positive acknowledge tone, then the internal dialling tone.
Replace the receiver.
Lift the receiver.
Dial the external number of the system which has been configured for remote access in
Numbering->Call Distribution->Incoming Distribution unter Assignment.
If external access to your system is enabled in the GUI, you will hear the special dialling
tone of your system. Switch your telephone to tone dialling .
Choose PIN 2 as configured in the GUI.
Press the * key or the # key respectively (set up / delete Follow me ).
Dial the code for Follow me.
Select the intended internal number the calls to which shall be transferred.
Press the * key.
Dial the number of the subscriber to which the calls are to be transferred. The subscriber
can be internal to the system or external.
Confirm your input with the # key.
You hear the positive acknowledge tone, then the internal dialling tone.
Replace the receiver.
Lift the receiver.
Choose the number that you want to use for Call Through.
You hear a simulated external dialling tone.
Depending on configuration of the elmeghybird, entry of a 6-digit PIN2 may be required.
Dial the external destination number.
Have your conversation.
4 Operation via the telephone
23