Teldat elmeg hybird 300 Benutzerhandbuch Seite 51

Teldat GmbH
(d) Click OK.
(e) Store the configuration using the Save configuration button above the menu navigation.
Note the following rules on password use:
• The password must not be easy to guess. Names, car registration numbers, dates of birth, etc. should not be
chosen as passwords.
• The password should be at least 8 characters long.
• The password should include at least four distinct characters.
• The password should contain characters from at least three of the following four groups. Lower case letters (a - z),
upper case letters (A - Z), numbers (0 - 9), symbols
• Change your password regularly, e.g. every 90 days.
3.2.2 Network settings via assistants
Select the basic configuration in the menu Assistants->First steps->Basic Settings. For the LAN IP configuration,
the Address Mode is set by default to Static as your system is delivered ex works with a fixed IP. As Default Gate-
way IP Address, enter the IP address of your upstream router. Enter the same IP address of the upstream router
under DNS Server.
This configures the settings for integrating your device into the local network (LAN).
3.2.3 Telephony
The elmeg hybird system is a PBX setup to which you can also connect IP system telephones and standard IP tele-
phones. Below is described how to connect and log in an IP system telephone to your system.
SIP provider
In the first step, you create a SIP provider and set up a corresponding connection:
(1) In the GUI, select VoIP->Settings->SIP Provider->New.
(2) Enter you SIP account data. For example, the data might look as follows:
Field
Description
Authentication ID
Password
Registrar
(3) Confirm your settings by clicking OK.
You will see your SIP connection under Numbering->Trunk Settings ->Trunks.
Call number
In the following step, you configure your connection's subscriber number.
(1) Select Numbering->Trunk Settings ->Trunk Numbers ->New in the menu and select your SIP provider under
Trunk (in this example:
(2) Under Displayed Name, enter the corresponding name (e.g.
number assigned to you by your SIP provider. Make sure the format is correct. It's important to enter the country
code (if required) without
(3) Save your entries with OK.
Authorisation class
As the next step, you select the authorisations associated to this entry:
hybird 300 / hybird 600
Description
Enter the name of your SIP provider, e.g.
Enter your ID, e. g. for Sipgate:
Enter the password you received from the SIP provider.
Enter the relevant registrar. For Sipgate:
).
; (e.g. for Germany
.
), and under Single Number (MSN), the
).
3 Basic configuration
7