Configuring The System - Teldat elmeg hybird 300 Benutzerhandbuch

3 Basic configuration
Checking the TCP/IP protocol
Proceed as follows to check whether you have installed the protocol:
(1) Click the Windows Start button and then Settings -> Control Panel -> Network Connections (Windows XP) or
Control Panel -> Network and Sharing Center-> Change Adapter Settings (Windows 7).
(2) Click on LAN Connection.
(3) Click on Properties in the status window.
(4) Look for the Internet Protocol (TCP/IP) entry in the list of network components.
Installing the TCP/IP protocol
If you cannot find the Internet Protocol (TCP/IP) entry, install the TCP/IP protocol as follows:
(1) First click Properties, then Install in the status window of the LAN Connection.
(2) Select the Protocol entry.
(3) Click Add.
(4) Select Internet Protocol (TCP/IP) and click on OK.
(5) Follow the on-screen instructions and restart your PC when you have finished.
Allocating PC IP address
Allocate an IP address to your PC as follows:
(1) Select Internet Protocol (TCP/IP) and click Properties.
(2) Choose Use next IP address and enter a suitable IP address.
Enter the gateway IP address on your PC.
Then continue by entering the IP address of the gateway in the configuration of your PC as follows:
(1) In Internet Protocol (TCP/IP) -> Properties under Default gateway, enter the IP address of your gateway.
(2) Enter the IP address of your device under Use next DNS server address.
(3) Click OK.
(4) Close the status window withOK.
The computer now has an IPSec configuration.
Note
You can now launch the GUI for configuration by entering the IP address of your device
(192.168.0.250) in a supported browser (Internet Explorer 6 or later, Mozilla Firefox 1.2 or later) and
entering the pre-configured login information (User:

3.2 Configuring the system

3.2.1 Modify system password
All elmeg devices are delivered with the same username and password. As long as the passwords remains un-
changed, you are thus not protected against unauthorised use. When first logging in, you must change the pass-
words to be able to configure your device.
To change the password, proceed as follows:
(a) Go to the System Management->Global Settings->Passwords menu.
(b) Enter a new password for System Admin Password .
(c) Enter the new password again under Confirm Admin Password .
6
, Password: ).
Teldat GmbH
hybird 300 / hybird 600