Room Monitoring From An External Telephone - Teldat elmeg hybird 300 Benutzerhandbuch

Teldat GmbH

Room monitoring from an external telephone

You are using an external telephone. Lift the receiver on the telephone from which you would like to carry out room
monitoring and dial the external call number allocated to the internal service number of the hybird.
If remote access is enabled and available at this point, you will hear the special dialling tone of your hybird. Set your
telephone to tone dialling or use a manual tone dialling transmitter.
Room monitoring from an external extension can only be initiated using the remote access of the hybird . To do this,
dial a specific number of the hybird from an external telephone, which is assigned in the configuration of the service
number (internal virtual extension). Using a 6-digit PIN, the hybird checks the permission for remote access. If after
entering the PIN successfully the internal number of the room-monitoring telephone is entered, the hybird estab-
lishes a connection to this telephone. The caller can acoustically monitor the room in which the telephone in question
is located via this connection.
Note
Room monitoring can only be enabled on the monitored telephone.
End room monitoring
If room monitoring is ended by the caller, the performance feature remains enabled on the room-monitoring tele-
phone. Additional room monitoring is possible from an internal or external telephone. If the receiver on the room-
monitoring telephone is replaced or hands free is deactivated, no other connections are available for room monitor-
ing. The performance feature is then switched off.
4.2.11 Assign project numbers /client numbers
Project number for a self-initiated call
hybird 300 / hybird 600
Lift the receiver of the telephone you want to use to monitor the room. You will hear the
internal dial tone.
Dial the internal telephone number of the telephone to be monitored.
You hear the positive acknowledge tone.
Room monitoring is in operation.
Enter the 6 digit PIN 2.
You hear the positive acknowledge tone.
Dial the number of the telephone to be monitored.
You hear the positive acknowledge tone.
Room monitoring is in operation.
Lift the receiver.
Dial the code.
Enter a project number (max. 6 characters).
Press the key.
You hear the positive acknowledge tone.
4 Operation via the telephone
15