Diagnostic Suite; Instrument Setup - Interacoustics AD629 Gebrauchsanweisung

AD629 Instructions for Use - US Page 35

3.9 Diagnostic suite

This section describes the data-transfer and hybrid mode (On-Line / PC-operated modes) supported by
AD629.

3.9.1 Instrument setup

The setup is similar to that described in the previous chapter for audiometric data transfer.
Important: Please be sure to selected the "AD629 (version 2)" (and not "A D629", which refers to the old
version).
PC controlled instrument: Unselect this if you want to run the AD629 as a standalone audiometer (i.e.
not as a hybrid audiometer) but still being connected to the Diagnostic Suite. When pressing Save
Session on the instrument, the session will automatically be transferred to the Diagnostic Suite. See
below section "Sync Mode".
Upload Print Logo and Audiogram Symbols to AD629: A logo for direct print outs can be transferred
to the AD629 using the "Up Print Logo" button. The symbol scheme used in the Diagnostic Suite can be
transferred to the AD629 (when viewing the build in audiogram) by using the "Upload Custom Symbols"
button. Please refer to the AD629 operational manual for info on how to change the symbol scheme on
the AD629.