Tips And Advice On Operation; Frost Protection; Technical Data - SOMFY S&SO-RS100 io Anleitung

EN

3.7. TIPS AND ADVICE ON OPERATION

3.7.1. Questions on the S&SO-RS100 io?
Observations
The roller shutter does
not operate.
If the roller shutter still does not work, contact a home motorisation and automation
professional.
3.7.2. Detecting obstacles
Automatic obstacle detection makes it possible to protect the roller shutter apron and
clear away obstacles:
If the roller shutter apron comes up against an
-
obstacle when moving down then, depending on
the position of the obstacle:
‡ Either the roller shutter stops automatically.
‡ Or it stops and is raised again automatically.
If the roller shutter apron encounters an obstacle
-
when moving upwards, the roller shutter stops
automatically.

3.7.3. Frost protection

Frost protection functions in a similar way to obstacle detection:
If the S&SO-RS100 io detects resistance, it stops automatically to protect the roller
-
shutter apron:
The roller shutter remains in its initial position.
-
3.7.4. Replacing a lost or broken Somfy io-homecontrol
To replace a lost or broken io-homecontrol
automation professional.

4. TECHNICAL DATA

Radio frequency
Power supply
Operating temperature
Protection rating
Maximum number of control points
associated sensors
Safety level
Somfy hereby declares that the drive covered by these instructions when marked for input voltage 230V 50Hz when
used as intended according to these instructions, is in compliance with the essential requirements of the Machinery
Directive 2006/42/EC and the R&TTE Directive 1999/5/EC.
$Q (& GHFODUDWLRQ RI FRQIRUPLW\ GHWDLOLQJ VWDQGDUGV DQG VSHFL¿FDWLRQV XVHG DQG VWDWLQJ DOO SDUWLFXODUV IRU LGHQWL¿FDWLRQ RI WKH GULYH
QDPH DQG DGGUHVV RI WKH SHUVRQ V DXWKRULVHG WR FRPSLOH WKH WHFKQLFDO ¿OH DQG HPSRZHUHG WR GUDZ XS WKH GHFODUDWLRQ LQFOXGLQJ SODFH
and date of issue can be found at the Internet address www.somfy.com/ce.
10
Copyright © 2014 - 2015 Somfy SAS. All rights reserved.
Possible causes
The io-homecontrol ® control point
battery is low.
The drive is in frost protection
.
mode
The overheating protection on the
drive has been activated.
and
Check the battery and replace it as required.
Refer to the guide for the control point.
Wait until the temperature reaches a point
where the roller shutter can move again.
Wait for the drive to cool down.
®
®
control point, contact a home motorisation or
868-870 MHz io-homecontrol® two-way Tri-band
230 V 50 Hz
- 25°C to + 60 °C
IP 44
9
Class II
Solutions
control point
Non contractual images.