Additional Settings; Tips And Advice On Operation - SOMFY S&SO-RS100 io HYBRID Anleitung

3.2.6. Additional settings

3.2.6.1. Modification of the favourite position (my)
Set the roller shutter to the desired favourite position
1)
(my).
my
Press , for ≈ 5 s, until there is back and forth
2)
movement by the roller shutter: the desired favourite
position (my) is now programmed.
3.2.6.2. Deleting the favourite position (my)
my
Press : the roller shutter moves and stops at
1)
the favourite position (my).
my
Press again until the roller shutter moves:
2)
the favourite position (my) is deleted.
3.2.6.3. Adding/Deleting Somfy io-homecontrol
Refer to the corresponding guide.

3.3. TIPS AND ADVICE ON OPERATION

3.3.1. Questions on the S&SO-RS100 io HYBRID?
Observations
The roller shutter does
not operate.
The roller shutter
detects obstacles
more or less quickly.
If the roller shutter still does not operate, contact a home motorisation and automation professional.
3.3.2. Obstacle detection when moving downwards and Smart Protect
Automatic obstacle detection protects the roller shutter apron and allows for any obstacles to be
removed.
Thanks to the intelligent and self-adaptive Smart Protect function, the S&SO-RS100 io HYBRID
automatically selects the most suitable obstacle detection sensitivity for the roller shutter. This function
allows the motorised roller shutter to adapt its behaviour throughout its life taking into account its
installation, its environment, as well as its ageing.
During the first 9 cycles, the Smart Protect function learns its environment: the roller shutter is protected
by a standard detection sensitivity. Then, the most appropriate sensitivity is defined, and re-evaluated
continuously.
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
Possible causes
The io-homecontrol control point
®
battery is low.
The drive is in frost protection mode
The overheating protection on
the drive has been activated.
The temperature protection of
S&SO-RS100 io HYBRID takes
several parameters into account and
can therefore be triggered to protect
it even though the tube temperature
is not high.
The Smart Protect function
automatically adjusts the obstacle
detection sensitivity so as not to
generate untimely stoppage (e.g.
slight friction in the guide rails).
1)
1)
control points and sensors
®
Check the battery and replace it as required.
Refer to the guide for the control point.
Wait until the temperature reaches a point
.
where the roller shutter can move again.
Wait for a few minutes.
Normal behaviour. The Smart Protect
function is activated.
EN
2)
my
my
2)
my
my
Solutions
Non contractual images.
63