Tips And Recommendations; Questions About The Sunea Csi Rts; Replacing A Lost Or Broken Rts Control Point; Restoring The Original Configuration - Somfy Sunea Csi Rts Gebrauchsanleitung

8. Tips and recommendations

8.1 Questions about the Sunea CSI RTS ?

Observations
The awning does not
operate.
The awning stops too
soon.
The awning is stuck
in the lowest position
and can only be
lowered.

8.2 Replacing a lost or broken RTS control point

Refer to the corresponding guide.
8.3 Restoring the original configuration
This reset deletes all the RTS control points, all the sensors, all the end limit settings and resets
the motor's direction of rotation and favourite position (my). However, the advanced functions
setting ("Back impulse", "Back release", "Closing force") are kept.
Only switch off the current for the motor to be reset.
Do not use the Inis RT/Inis RTS control point for resetting.
1) Set the awning to the halfway position (if possible).
2) Cut the power supply off for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply off for 2 seconds.
5) Switch the power supply back on: The awning moves
for several seconds.
if the awning is in the upper or lower end limit position
it will make a brief movement.
6) Press and hold the PROG buttons: the awning will
make a first movement, and repeat it a few moments
later.
The motor is configured with the factory settings.
- Repeat the procedures in the chapter "
Copyright © 2009 Somfy SAS. All rights reserved.
Possible causes
The wiring is incorrect.
The motor is hot.
An incorrect cable has been
used.
The RTS control point battery is
weak.
The RTS control point is not
compatible.
The RTS control point used has
not been programmed into the
motor.
There is radio interference.
The crown is incorrectly
positioned.
The end limits have been
incorrectly set.
Bad repositioning of the end
limits after cutting the power
supply and/or using the
emergency crank.
Commissioning".
Solutions
Check the wiring and modify it if
necessary.
Wait until the motor cools down.
Check the cable and ensure it has 3
leads.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
RTS control point if necessary.
Use a programmed RTS control point or
program this RTS control point.
Turn off all radio equipment nearby.
Fit the crown correctly.
Readjust the end limits.
Using the emergency crank, up the
awning in its median position and give
an up order using the RTS control point.
1
5 secs
3
ON
15 secs
5
ON
6
PROG.
Sunea CSI RTS
2
OFF
2 secs
4
OFF
2 secs
my
19