Operation And Maintenance; Up And Down Buttons; Stop Function; Favourite Position - SOMFY S&SO-RS100 io Anleitung

3. OPERATION AND MAINTENANCE

This drive does not require any maintenance operation.
If no io-homecontrol
automation professional.

3.1. UP AND DOWN BUTTONS

A brief press on
move all the way up or all the way down.

3.2. STOP FUNCTION

The roller shutter is moving.
%ULHÀ\ press the
-
stops automatically.
3.3. FAVOURITE POSITION (my)
An intermediate position called "favourite position (my)" other than the fully up or fully
down position is programmed by default in the S&SO-RS100 io.
Perform 2 complete
-
shutter to activate the favourite position.
To modify or delete the favourite position (my), see section Additional settings.
To use the favourite position (my):
my
%ULHÀ\ press
-
stops in the favourite position (my).

3.4. OPERATION WITH A Somfy io-homecontrol

SUNIS WireFree™ io)
Refer to the corresponding guide.

3.5. FEEDBACK

The S&SO-RS100 io sends a message after each order. This information is processed by
®
the io-homecontrol

3.6. ADDITIONAL SETTINGS

 0RGL¿FDWLRQ RI WKH IDYRXULWH SRVLWLRQ P\
Set the roller shutter to the desired favourite
1)
position (my).
my,
Press IRU § 5 s, until there is back and
2)
forth movement by the roller shutter: the desired
favourite position (my) is now programmed.
3.6.2. Deleting the favourite position (my)
my
Press : the roller shutter moves and stops at
1)
the favourite position (my).
my
Press again until the roller shutter moves: the
2)
favourite position (my) is deleted.
3.6.3. Adding/Deleting Somfy io-homecontrol
Refer to the corresponding guide.
Copyright © 2014 - 2015 Somfy SAS. All rights reserved.
®
control point is programmed: contact a home motorisation and
V
or causes the roller shutter to
my
button: the roller shutter
V
or cycles as far as the upper and lower end limits of the roller
: the roller shutter moves and
two-way control points.
my
®
SUN SENSOR (SUCH AS
1)
my
1)
my
®
control points and sensors
Non contractual images.
EN
my
2)
my
2)
my
9