Modifying The Direction Of Rotation; Installation Tips And Advice - SOMFY Sonesse 40 io Anleitung

Sonesse 40 io
2.3.5. Re-setting the end limits
Readjusting the upper end limit
1) Press the Up button on the control point to move the motorised
product to the end limit to be readjusted.
2) Press the Up and Down buttons at the same time until the motorised
product moves up and down.
3) Press the Up or Down button to move the motorised product to the
new desired position.
4) To confirm the new end limit, press the my button until the motorised
product moves up and down.
Readjusting the lower end limit
1) Press the Down button on the control point to move the motorised
product to the end limit to be readjusted.
2) Press the Up and Down buttons at the same time until the motorised
product moves up and down.
3) Press the Up or Down button to move the motorised product to the
new desired position.
4) To confirm the new end limit, press the my button until the motorised
product moves up and down.

2.3.6. Modifying the direction of rotation

1) Position the motorised product at the mid-height position.
2) Press the Up and Down buttons at the same time until the motorised
product moves up and down.
3) Press the my button until the motorised product moves up and down.

2.4. INSTALLATION TIPS AND ADVICE

2.4.1. Questions about the Sonesse 40 io?
Observations
The motorised
product does
not work.
Copyright 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Possible causes
The wiring is incorrect.
The drive is in thermal protection mode.
The control point battery is low.
The control point is not compatible.
The control point used has not been
programmed into the drive.
1)
3)
1)
3)
1)
3)
Solutions
Check the wiring and modify it if necessary.
Wait for the drive to cool down.
Check whether the battery is low and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or program
this control point.
EN
2)
4)
2)
4)
2)
13