Additional Settings; Tips And Advice On Operation; Frost Protection - SOMFY S&SO-RS100 io HYBRID Anleitung

3.2.6. Additional settings

 0RGL¿FDWLRQ RI WKH IDYRXULWH SRVLWLRQ P\
Set the roller shutter to the desired favourite
1)
position (my).
my
Press  IRU § 5 s, until there is back and
2)
forth movement by the roller shutter: the desired
favourite position (my) is now programmed.
3.2.6.2. Deleting the favourite position (my)
my
Press : the roller shutter moves and stops at
1)
the favourite position (my).
my
Press again until the roller shutter moves:
2)
the favourite position (my) is deleted.
3.2.6.3. Adding/Deleting Somfy io-homecontrol
Refer to the corresponding guide.

3.3. TIPS AND ADVICE ON OPERATION

3.3.1. Questions on the S&SO-RS100 io HYBRID?
Observations
The roller shutter
does not operate.
If the roller shutter still does not work, contact a home motorisation and automation
professional.
3.3.2. Detecting obstacles
Automatic obstacle detection makes it possible to
protect the roller shutter apron and clear away
obstacles:
If the roller shutter apron comes up against an
-
obstacle when moving down then, depending on
the position of the obstacle:
‡ Either the roller shutter stops automatically.
‡ Or it stops and is raised again automatically.
If the roller shutter apron encounters an obstacle
-
when moving upwards, the roller shutter stops
automatically.

3.3.3. Frost protection

Frost protection functions in a similar way to obstacle detection:
If the S&SO-RS100 io HYBRID detects resistance, it stops automatically to protect the
-
roller shutter apron:
The roller shutter remains in its initial position.
-
3.3.4. Replacing a lost or broken Somfy io-homecontrol
To replace a lost or broken io-homecontrol
automation professional.
Copyright © 2014 - 2015 Somfy SAS. All rights reserved.
Possible causes
The io-homecontrol ® control
point battery is low.
The drive is in frost protection
.
mode
The overheating protection on
the drive has been activated.
1)
1)
®
control points and sensors
Check the battery and replace it as
required. Refer to the guide for the control
point.
Wait until the temperature reaches a point
where the roller shutter can move again.
Wait for the drive to cool down.
®
control point
® control point, contact a home motorisation or
2)
my
2)
my
Solutions
Non contractual images.
EN
my
my
15