Record Operation; 26 5.1 For Users In A Hurry - uher SG 561 Royal Bedienungsanleitung

As the quality of a recording depends largely upon correct setting of the record level, especial attention should be given to the process of level
adjustment (see also sec. 5.23).
5.1 For Users in a Hurry
Proceed äs follows:
1. Connect the desired input source to the appropriate socket and
connected, but they should be switched off. (Using the Microphone
Switch © , cut microphone input in or out of circuit, äs appropriate.)
2.
3.
ing on the power supply.
4. Load tape äs described in sec. 1.7 above and set Mode Selector ©
to the operating mode to be used in recording.
5. Press Record Button ® and hold down while setting the Tape
Transport Switch ® to PAUSE position.
6. Press Counter Reset Key ® or note index number so that the re-
cording may be accurately marked for later cataloguing.
7. Using the appropriate Level
adjust record level so that the record level meters © and © read
exactly 0 dB at the loudest Programme passages to be recorded.

5. Record Operation

Controls @ and © or @ and © ,
8. Set the Tape Transport Switch ® to START, and recording will begin.
9. Recording may be interrupted by switching from START to PAUSE,
but the machine will remain in record mode.
10. After recording one complete run of the tape, exchange the füll
right spool with the empty left spool and continue recording, äs des-
cribed above, on the second track(s). (In dual-track stereo Operation:
rewind tape, then continue recording on another tape.)
MONITOR Switch in TAPE position. In that way the possibility of
acoustic feedback between microphones and Speakers (recognizable
by the howl and whistling noises produced) will be prevented, and
secondly, disturbing background noises may be detected immediately
and perhaps be avoided by altering microphone placement while
recording.
and Programme selections should be noted on the tape lead, on
the tape spool and on the tape storage box.
33