Setting Up The Sg 561 Royal; Air Circulation; Operating Position; Extension Of Connecting Leads - uher SG 561 Royal Bedienungsanleitung

1.1 Air Circulation

In setting up the SG 561 Royal, care must be taken that all ventilating
tion äs needed for proper heat exchange. When bullding the unit into
a cabinet or set of wall shelves, be certain to allow for sufficient air supply.

1.2 Operating Position

The SG 561 may be operated in either vertical or horizontal position.
Two holes (A) are provided on the bottom side (or rear) of the unit's
housing for hanging the unit on wall hooks (see Fig. 1).
When matching UHER plug-in extension leads (see list at end of Oper-
ating Instructions) are not used, connecting leads should be extended
Fig. 1
24
(Figs. 1 and 2)
The mains power lead is located in the recess (B) in the floor (or rear)
of the unit's housing. To open the compartment lid, push the self-catching
key (C) of the lock in the direction indicated by the arrow and flip the
lid up or out.
Before plugging the lead into a mains power outlet - especially when
outside of Germany - ascertain the voltage of the power supply. The
SG 561 has been factory-set to an operating voltage of 220 V A.C. 50 Hz,
but it may be adjusted to operate on 110 V, 130 V, 150 V, 240 V or
250 V.
To adjust the voltage, proceed äs follows (see Fig. 2):
1.
power supply. Using a coin, then unscrew the fuse holder (A) which,
ment.
2. For Operation on voltages from 220 V to 250 V, insert an 0.6 A
fuse; for voltages from 110 V to 150 V use a 1.2 A fuse. Then screw
the fuse holder back in.
110-150 V = 1,2 AI
Fig. 2
A B C