Access To The Personalisation Through External Software; Final Start Up Sequence - Eaton EX RT 7 Installationsaleitung

ON/OFF features
Function
Cold start
Forced reboot
Automatic restart
Sleep mode
UPS ON/OFF by software
Personnalisation batterie
Function
Battery test
Low battery signal
Run time choice
Battery deep discharge
protection
Use EXIT key when set up is completed.
z
These parameters are only adjustable if
z

Access to the personalisation through external software

Insert the
z
z At the first Navigator Screen, select "Installation" and follow the instructions to install
Solution-Pac for Windows.
If nothing appears, launch startup.exe
z
Then go to "Advanced settings" and "UPS settings".
z
Please note that the Linux/Unix/MacOS versions of Personal Solution-Pac do not include this feature.

3.2 Final start up sequence

z Press the ON button more than 3 seconds.
After UPS internal test sequence, the green LED
z
During the restart, if the Bypass AC source is out of tolerance, the UPS will generate an output 10 ms calibrated
break.
Factory setting
Disabled
Enabled
Enabled
Disabled
Enabled
Factory setting
Every week
20 %
UPS reads # of battery
modules connected
Enabled
Solution-Pac CD ROM in your CD drive.
Options Comments
Enabled Start on battery.
Disabled Enables automatic restart of the system
even if normal AC source is restored before
the end of the shutdown sequence.
Disabled UPS restarts automatically
when normal AC source is restored.
Automatic shudown on battery if output
Enabled
load level < 10%.
Disabled Enables consideration of shutdown
or restart orders from software to be
authorized.
Options
No test / daily / monthly
0 to 100 %
From 50 to 400 Ah
Disabled
UPS is OFF.
13 goes on.
3. Operation
Comments
1% increment.
Requires EX RT CLA if using
options (see section 1.4
"Battery extensions").
If disabled, lost of EATON
warranty.
Personal
34007724EN/AD - Page 27