Connecting The Pressure Pipe; Fastening To The Floor; Installing The Control Unit - Kessel Aqualift F Mono Anleitung Für Einbau, Bedienung Und Wartung

Depending on the system design, fittings made of plastic
or cast iron are used.
1)
Fitting made of plastic
• If necessary, fit the shut-off valve (option).
• Connect pressure pipe <A>
• vertically to the drain connection <20>.
• horizontally to the shut-off valve.
Heed tightening torques, see page 6.4.
4.2.4

Fastening to the floor

Only use the screws <36> provided for attaching the
retaining brackets <37> to the wastewater tank. Other
screws can lead to leaks in the tank.
• Attach the retaining brackets at the four
the wastewater tank.
• Use the fastening material (7) provided
to fix the retaining brackets to the ground
(min. extraction resistance 0.9 kN*).
• The screws included in the scope of supply have been
designed for concrete floors (B25, 0.9 kN extraction resistance).
4.3.

Installing the control unit

• Install the control unit according to the operating and maintenance instructions for the control unit. During
installation, connect the electrical connections from the pump(s) and the pressure sensor (alternatively other
level sensors) to the control unit.
The connection lengths (cable, pressure pipe) can be extended as follows:
Floating switch and level probe
Pressure sensor
Pump(s)
• Following initialisation, enter the system parameters as follows:
Control unit KESSEL Aqualift F Standard 400V (see chapter 8)
Control unit KESSEL Aqualift F Comfort 230V
- Type Aqualift: Lifting station F xxx l (xxx = tank volume)
- Pump type: According to delivery note
INSTALLATION
as follows:
2)
points on
1)
Standard extendable to
5 m
5 m
5 m
40/168
17
15 m
15 m
30 m
A
20
[9]
37
36
7
[10]
2017/10