Care And Maintenance - Cocraft HMD 150 Bedienungsanleitung

Attaching the flexible drive shaft
Warning: Turn the power tool off and unplug it before attaching any accessories.
1. Unscrew the nose collar (3). Pull the drive wire (12) a short way out of the flexible
drive shaft (11) and grip the end of it in the 3.2 mm collet chuck (1).
11
2. Screw the flexible shaft to the thread on
the power tool where the nose collar was.
3. Lock the spindle of the flexible drive shaft
by inserting the spindle lock pin (9) into
the hole on the nose.
4. Undo the flexible drive shaft collet chuck
(10) and insert the desired accessory
before tightening it again.

Care and maintenance

• Always keep the ventilation openings of the motor free of dust and debris.
• Clean the power tool as needed using a lightly moistened cloth and mild detergent
if necessary.
• Avoid using solvents and abrasive cleaning agents.
12 1
9
11
10