Cleanmaxx Z 07338 Gebrauchsanleitung Seite 25

Emptying the dust container and cleaning the dust fi lter
6. Insert the dust container in the device: Take hold of it by the handle and insert
the bottom of the bin in the device fi rst. Then push the handle against the device
housing until the dust bin audibly locks into place. Hold the device by the handle and
lift it to check whether the dust bin is properly seated.
25
1. Push the release button on the dust bin and pull it out of
the device by the handle.
2. Hold the dust bin over an open garbage bin. The dust bin
should be as close as possible to the garbage bin so that
dust from the dust bin only falls into the garbage bin and
is not dispersed in the surrounding area.
3. Push the button to open the dust bin. The bottom of the
dust bin will open and the dirt will fall out.
4. Shut the bottom of the dust bin again. The fastener must
audibly lock into place.
5. If necessary, thoroughly rinse the dust container and the
plastic dust fi lter with clear, lukewarm water.
– Open the dust container lid by releasing the catch on
the handle and fl ipping up the lid.
– Remove the white dust fi lter and the black foam dust
fi lter. Tap out the contents of the fi lter over a dustbin
and brush off the loose dirt. Never clean the white
dust fi lter with water! If necessary, the black foam
dust fi lter may be cleaned clear, lukewarm water.
CAUTION: Do not under any circumstances clean
the fi lter in a washing machine or dishwasher!
Shake off any excess water and allow the dust fi lter to
dry completely in the air before reinstalling them.
– Remove the plastic dust fi lter by pulling it out of the dust
container. If necessary, thoroughly rinse the dust container
and the plastic dust fi lter with clear, lukewarm
CAUTION: Do not under any circumstances clean the
dust container or the plastic dust fi lter in a washing
machine or dishwasher! Shake off any excess water
and allow the dust container and the plastic dust fi lter to
dry completely in the
into the dust container when it is completely dry.
air. Place the plastic dust fi lter back
EN
water.